Any ideas what

ELT could not be completed: Cannot start tap: Catalog discovery failed:

might be about ? (from tap-spreadsheets-anywhere reading a simple csv file over http)

did you see this error when running

meltano elt

from the command line? What happens if you run

meltano invoke tap-spreadsheets-anywhere --discover

?

@andrew_stewart Is

Catalog discovery failed

followed by anything? That error message is coming from either https://gitlab.com/meltano/meltano/-/blob/6a8fae1a9d5a36e936d363389edb9e0038338c44/src/meltano/core/plugin/singer/tap.py#L269 or https://gitlab.com/meltano/meltano/-/blob/6a8fae1a9d5a36e936d363389edb9e0038338c44/src/meltano/core/plugin/singer/tap.py#L295, and in both cases, the output should include a specific error message.

I believe I’ve traced the error down to the tap not actually supporting HTTPS protocol. Which is confusing because the README on the tap says it does, but I verified in the code that it only has handlers for s3, ssh, gs and local.

Ah, that's unfortunate

Related to the above question - I've seen this error before too, and at first I wasn't sure what the actual issue was since the error wasn't surfaced in the UI modal or the log file you can download

@al_whatmough Please do! The full CLI output should always end up in the log file (and modal), so if the error doesn’t, that’s a bug!

@douwe_maan no worries, I'll create an issue when I'm back on my laptop! This particular tap was working without error before, but I realise it wasn't outputting a catalog properly when run in discover mode. I only started getting an error in Meltano when upgrading from 1.47 to 1.58 though, so I guess some change between these versions changed the way it handles that type of error